Cricut Christmas Decor

Hi friends,

Thanks so much for stopping by today!

Do you have scrap wood laying around. If you are like us, you probably do. Well go ahead and grab a piece and make this super simple Cricut Christmas Decor

So, this is the first side, did I mention it was double sided? Let me share what I did. I had the hubby spray paint the wood for me, so much faster than using a brush 🙂 I took scrapbook paper can cut it a little smaller then the wood, I adhered it to the wood using modpodge. I make my own by mixing two parts glue to one part water, works just as good as the real stuff!

You want to apply a THIN layer of modpodge to the wood, then apply your paper. Add more modpodge over the paper (again, a thin layer(. If you find air bubbles, dip your finger in the modpodge and push the bubbles out.

I did both sides of the wood the same way, allowing one side to dry completely.

Inside Cricut Design Space,, I created a template the same size as my paper, found some sayings I liked, and just like that we have DIY Christmas Decor.

Here is the other side:

I did Christmas on both sides. I also did not add any 3d embellishments, this way I wouldn’t need to worry about anything falling off and makes it much easier to store!

For the lettering, I just used card stock. I applied a thin layer of modpodge to the paper, added the lettering, then applied more modpodge over the lettering. That easy!

Hope you give it a try, it was really easy.

Hugs, Stacy